EnCore v2 Placement

EnCore v2 is mounted inside the fixture by removing the back panel.

The power strip is located above the EnCore v2 in the image shown below.

IR Extender Cable (KF-1102)

The IR extender cables feed out the mouse holes in the fixture as shown in the image below.

Adhere the IR receiver dome underneath the bottom of each shelf.

Point your keyfob in the general area of the IR receiver dome to arm and disarm the EnCore v2 inside the wall fixture.

CR338, Titan L2QD

CR338 and Titan L2QDs are used to secure phones and tablets on the bottom 2 shelves.

The K-1106 mounting kit is used on this fixture to secure phones and tablets.

Their power cables exit out of the rear of the pedestal and feed underneath the panel.